NetXMS Support Forum

Firstly thanks again for everyone that contributes to the development of NetXMS. It beats the crap out of so many commercial software it aint even funny.

We use NetXMS to monitor a couple of hundred switches. At the moment I can select multiple ports on a switch and set the expected port status in one go to UP/DOWN/IGNORE.

But what I then do is I have to manually select every single port and right-click, Properties, and then go and change the status propagation to each and every port individually as Warning. I dont want to be notified that a device went down if a user unplug's his router from the network - but I would like to see it as a warning.

Is there a way to set all the ports propagation to Warning, or is this a new feature request?

Thanks!
Riaan