NetXMS Support Forum

Hi, i saw that version 5 was added aruba driver for switch,ap and gateway.
i have a aruba cx switches, but added on netxms (version 5.0.3) with snmp (i tried v2 and v3) the program load GENERIC driver
why?
thanks
Andrea

Hi,
HPE Aruba switch driver is selected only if it's SNMP object ID starts with "1.3.6.1.4.1.14823.1.1", we also check if we can get ".1.3.6.1.4.1.14823.2.2.1.2.1.3.0" OID form this device (model name).

Do you have any problems with Generic driver (like hardware information is not obtained,  wireless capabilities not detected, access point or wireless clients not shown)?

Tatjana

Hello,

i have aruba switch cx series 6300, 6200, 
SNMP object ID=1.3.6.1.4.1.47196.4.1.1.1.323
SNMP object ID=1.3.6.1.4.1.47196.4.1.1.1.324
SNMP object ID=1.3.6.1.4.1.47196.4.1.1.1.119

the driver generic is used, i cannot see vlan, arp, ports, fdb, vlan table etc....

how can i change it to use aruba driver ?

thank you

You can try setting custom attribute snmp.driver to value ARUBA-SW on the node.

Chances are that current Aruba driver does not support your devices. Pls update on the results.

no luck,

do you need an snmp walk output to add the switches to netxms ?

If you could provide us with access to some test aruba device for a few days, that would be the most efficient way for our developers. You can set up some vpn or just netxms agent with SNMP proxy enabled to which we could connect. If that's not possible, pls send full snmp walk output.

Hello,

where can i send you the snmpwalk files ?

thank you