NetXMS Support Forum

Greetings,

NetXMS 1.2.17 is not discovering all nodes, in 3 or 4 of our remote networks.  It discovered some nodes in those networks, but not all.  Is there a way to force a "re-discovery" of just a certain network?


-Kevin C.

If those nodes respond to ICMP ping, you can try to configure active discovery for problematic networks. Also, NetXMS will not add non-responding nodes - are they accessible from NetXMS server?

Best regards,
Victor

The nodes responded to pings from the server.  So I took another look at my discovery settings, and then recalled I had filtered out the upper end of the IP address ranges of those networks when I initially installed NetXMS !

I modified those filters, saved it, and within 5 minutes, NetXMS discovered the missing nodes... chalk this up to pilot error :-)


-Kevin C.