NetXMS Support Forum

Hi,

I've asked this question before, but I have to again, about the Notification Channel.
When adding a new Channel, do I select Portech and in the field for Driver Conf enter:
host=ip address
login=name
pass=pass
mode=TEXT

I manually send an SMS message and once it works, but the second time it reports an error, Driver error.
I have to set the configuration again and it works once again...

I set in the Server console:
debug nc.* 6
debug ncd.* 6
but there are no messages...

Helpp!!

Thanks, best regards.

Hi.

"pass" should be "password" in your config. Also debug tag "nc.*" should be "nc".

Correct confiration:

host=10.0.0.1
secondaryHost=10.0.0.2
login=user1
password=password1
mode=TEXT
mode can be either "TEXT" or "PDU". Secondary host is optional.

Sample session attached (added new notification channel and tried to send message to non-existing device):

Hi sir,

I tryed, but I can't do this at all:  debug tag "nc.*" should be "nc". 

And I have another problem, I installed NetXMS 4.1.420 on Linux Ubuntu 18.04 LTS.

Should the server address remain 127.0.0.1 or should it be changed to the server's own address (192.168.x.x), everything is local. Why am I asking you this, because when I create a node (Cisco Catalyst) and start with the Poll - Configuration option, I get the message:

Checking NetXMS agent...
Cannot connect to NetXMS agent (Connect failed) (Is this ok? Because the old version of NetXMS did not have this message...) Or I missed something...
Checking SNMP...
SNMP agent is active
...
etc