NetXMS Support Forum

When a node goes down, I get an alarm in the alarm browser.  When the node comes back up I get a Node up alarm in the alarm browser.  What I need is:
When the node up alarm arrives, I need the node down alarm to removed from the active alarms and the node up alarm to stay for 60 seconds, then be removed.  Is this possible?

Very Limited Knowledge here - but I was doing Similar adjustments Yesterday (although not time)

Configuarion - Event Processing Policy (in the Desktop Client) - Appears there is an Alarm timeout option under "Action - Alarm" - so if you find the right event being triggered, you should be able to set.  You may need to run these changes as system also - i really don't know yet (also, don't forget to save after the change)

Again, very fresh here - so backup and note changes - so you can revert if required...

Good Luck