NetXMS Support Forum

Hi everyone,
I am quite new to snmp and NetXMS. However, I must say that it's great.

I am monitoring a total of 12 switches and 6 network printer with no problems whatsoever.

Until, today my boss got a TASKalfa 3010i MFP. I configured it on the network, printed, scanned to emails and working like a charm will all 80 employees.

When I configure the MFP with NetXMS, I am having problems with the Ethernet port that was discovered with the printer (eth0) - the ONLY one available and present in it.

Eth0 is showing as Admin status UP and Operational status DOWN.

How can this be as the network connection is fine, without a single error and everyone is printing normally? I can ping the printer, access it's webpage, etc.

Can please someone drop me some ideas?

Thanks a lot in advance

Hi everyone,
I am new to NetXMS but, with the help of the manuals, I've managed to make miracles 

I currently have a hardware problem with a network switch. Basically, as soon as I try to add the switch to NetXMS, the switch goes nuts and reboots. The switch, then, works again once I remove its IP Address from NetXMS.

I am using NetXMS for Windows.

The manufacturer asked me to send him the NetXMS polling packets.

Can someone please guide me on how I can send him the polling packets log?

For your info, it's a D-Link DGS 1210-24, Rev. D with the latest firmware version. For those who have the same hardware, I am in contact with D-Link to fix the issue.

Thanks in advance.