NetXMS Support Forum

Hi,

it is the first time that I use NetXMS. I´ve try to get the interface description from a Cisco Switch via SNMP.
I´ve the SNMP OID and I try to configure a DCI. When I push the SNMP Walk Button everything is fine and
I can see the description´s. But after I push OK I´ve get an Error Message that the DCI Status was changed to unsupported....

I want that I can see the description (IFAlias) in the Interface table. Can anyone give me a short instruction how I can do this ?

Thanks a lot

M

Hi,

I´ve a Problem.
I request a FAN Status from a cisco Switch an get a value from 1-4 back.
The Datatype is an integer. I want to translate the value in a cleartext word like OK warning etc.
Can someone tell me how I can do this ? I´ve a solution, but it works for one poll, after the next one
I´ve get only 0.

Many Thanks !!!