NetXMS Support Forum

Hi Victor,

I assume you are sure about this as lead developer and I will mark this as resolved. But, I'm sure that I just now adjusted a threshold to be over the last value and the alarm disappeared, I guess it's some other mechanic I see.

I'll use DCI transformation to adjust my values instead of the threshold

Thanks,
John

Hi,

I have re-created the situation now, see attachments, but basically,

I create a warning-evert and a normal-event
I create an event processing policy
I set the threshold on the node DCI
The warning threshold is triggerd, the event registers in the event log
The alarm appears
I set the threshold value to a higher than the actual value to trigger a normal-event
No event in event log
The alarm is still visible
But, the DCI is OK in Last values view


BR,
John

Hi,

I use the same key to create the alarm as I do to terminate, I think this should be fine


I suspect that it might be working, one node raised an alarm... But I think the original one doesn't still (need to confirm when I'm at the office). I had modified the thresholds on both the node and the template multiple times, so I'm not sure if it was some kind of hickup somewhere.

Hi,

I am trying to make a custom event and custom event processing policy to generate alarm for Percentage of disk usage, but I cannot make the alarms auto-terminate when the disk usage goes under the threshold.

When I keep the default SYS_THRESHOLD_REARMED in data collection configuration -> threshold -> Deactivation event I can see it in the event log so I suspect my custom event.

Is there any way I investigate this further?