I've installed the NetXMS 1.1.10 agent on two Windows 2003 servers located at a separate disaster recovery facility. Communication between the two locations is performed using a VPN. The NetXMS host server is also Windows 2003.
When I attempt to add a DCI relating to any of the DISK. parameters, those parameters are not included in the Support Agent Parameters selection list. The list jumps from AGENT.VERSION to FILE.COUNT.
The corporate location uses a 192.168.2.0 IP structure and the DR site uses a 192.168.6.0 structure. Except for the IP address structure, all the servers are using the same templates and configuration settings. Other servers at the corporate location currently have some of the DISK. parameters in use.
Any idea as to why the difference in the available parameters between the two locations?
Hi!
In 1.1.x version, all Disk.* parameters was renamed to FileSystem.* parameters. Agent still understand old names, so you can use old templates for example, but they are not shown in the list of supported parameters anymore. If adding new DCI, just use appropriate FileSystem.* parameters.
Best regards,
Victor