We have some Huawei switches ( S5735-XXXX). They are discovered by NetXMS using GENERIC driver.
Interfaces tab looks good, but :
- Ports tab is empty;
- FDB tab shows MAC addresses for VLAN 1 only;
- there is no port picture on VLANs tab.
Is there any solution or workaround for this problem ?
Hi,
Looks like it is required to create driver for this type of devices. I wander if it possible to get remote access to this device (this way it is much faster to create and debug new driver)?
Hi,
What kind of remote access do you need - SNMP, CLI ?
SNMP is enough for testing the driver.
+1 upvote for this vendor driver
Hello @all,
having here a similar problem with a Netgear GS728TPv3.
Ports Tab ist empty, Interface List shows VLANs at wrong interface or VLAN fields are empty in interface List...
The correct values are:
VLAN1 is on port 1-18
VLAN2 is on port 19-24
NetXMS is using the GENRIC Driver.
Using here NetXMS V5.0.6 (Linux Debian / PostgreSQL)
Must i use a vendor driver for this switch type too?
Greetings
Marco
Quote from: Spheron on August 13, 2024, 02:08:09 PMhaving here a similar problem with a Netgear GS728TPv3.
Any chances we can get remote access to your device for a few days? SNMP-only access is enough, it can be some test device not connected to real network
Quote from: Filipp Sudanov on August 13, 2024, 02:17:52 PMQuote from: Spheron on August 13, 2024, 02:08:09 PMhaving here a similar problem with a Netgear GS728TPv3.
Any chances we can get remote access to your device for a few days? SNMP-only access is enough, it can be some test device not connected to real network
Hi Filipp,
sorry for the - very - late reply. Meanwhile Netgear released a new firmware with a vlan/snmp bugfix. After upgrade to newest switch firmware the VLAN infos in NetXMS are correct...
Greetings
Marco
Great, thanks for the update