Print Page - Issue with Alarm (Newbee) /2 ?

Title: Issue with Alarm (Newbee) /2 ?
Post by: LogicalNZ on October 17, 2017, 01:18:02 AM

I have a problem where I get error reports that state my network should be a /2 rather than a /24 (which is correct).

What do I do to resolve this please?

With thanks

Title: Re: Issue with Alarm (Newbee) /2 ?
Post by: Victor Kirhenshtein on October 18, 2017, 03:50:17 PM

Hi,

check if you have subnet object with /2 mask. If yes and it is not correct, delete it and run configuration poll on any router connected to problematic subnet with correct netmask. Most likely you have some machine with /2 mask and it was first in subnet discovered by NetXMS server.

Best regards,
Victor

Title: Re: Issue with Alarm (Newbee) /2 ?
Post by: LogicalNZ on October 18, 2017, 11:01:05 PM

Thanks Victor,

I have deleted that reconfigured the Node in NetXMS with the same issue. I have searched the router (MikroTik) and have no /2 subnets and networks so are a little lost :(

Title: Re: Issue with Alarm (Newbee) /2 ?
Post by: Victor Kirhenshtein on November 02, 2017, 10:22:42 AM

Hi,

could you show all parent subnets for this node?

Best regards,
Victor

NetXMS Support Forum

English Support => General Support => Topic started by: LogicalNZ on October 17, 2017, 01:18:02 AM