Print Page - Raise alarm after XX minutes

Title: Raise alarm after XX minutes
Post by: [email protected] on September 27, 2013, 04:47:47 PM

Hi guys,

I've downloaded Netxms and I am searching how to configure different time values before a specific node raises an alarm. For example :
- node1 should raise an alarm after 2 minutes of downtime
- node2 should raise an alarm after 15 minutes of downtime

How can we do that in Netxms ? I've found the condition section which seems to be used for that kind of cases yet I do not find a way to specify the time value and how to then associate it to the node.

Thanks in advance.

V.

Title: Re: Raise alarm after XX minutes
Post by: yshiro on September 27, 2013, 05:03:41 PM

Hi, you must configure it on "interface" of host. If your host have interface "Local Network", click right button on interface/properties/polling/polling count. If the polling of host it´s 1 minute and you configure 5 polling, will raise alarm at 5 minutes.

Greetings.

Title: Re: Raise alarm after XX minutes
Post by: [email protected] on September 27, 2013, 06:50:37 PM

Hi,

Thanks for the prompt reply. I see only one value for the required poll count. Is there a way to use two different values for the UP and DOWN alarm ?

Example, when node or interface stops replying requests alarm is generated after 5 poll count but if interface node comes back on it instantly generates the UP alarm ?

Thanks.

V.

NetXMS Support Forum

English Support => General Support => Topic started by: [email protected] on September 27, 2013, 04:47:47 PM