Print Page - Set a new standard retention time?

Title: Set a new standard retention time?
Post by: xenth on April 04, 2008, 03:51:44 PM

Is it possible to set a different retention time? I couldn't find it in the options and it would save me a lot of time! :)

Thanks in advance

Title: Re: Set a new standard retention time?
Post by: Victor Kirhenshtein on April 04, 2008, 05:35:07 PM

Hello!

Retention time for what? Each DCI has it's own retention time for collected data. It is configured in DCI properties dialog. Retention time for event log, trap log, etc. can be configured via server configuration parameters, accessible through Control Panel -> Server Configuration.

Best regards,
Victor

Title: Re: Set a new standard retention time?
Post by: xenth on April 07, 2008, 02:02:39 PM

Sorry should have been clearer, what I meant to say was: How do I configure all DCI's to have a higher retention time, or can this only be done manually?

Title: Re: Set a new standard retention time?
Post by: Victor Kirhenshtein on April 07, 2008, 04:24:15 PM

Unfortunately, it can be done only manually. I'll add it to wish list. As a workaround for mass update you can stop NetXMS server and do update directly in database. Also, using templates for commonly used DCIs will help a bit.

Best regards,
Victor

Title: Re: Set a new standard retention time?
Post by: xenth on April 08, 2008, 01:04:30 PM

Thanks Victor!

NetXMS Support Forum

English Support => General Support => Topic started by: xenth on April 04, 2008, 03:51:44 PM