Text only | Text with Images

NetXMS Support Forum

English Support => General Support => Topic started by: lindeamon on July 25, 2012, 12:41:12 PM

Title: stack ports
Post by: lindeamon on July 25, 2012, 12:41:12 PM
hi victor,

i have discovered my dell power connect with the driver and i saw that the 10gb ports which are stack ports are in an unknown state.
bug ?

Best Regards,
Lindeamon
Title: Re: stack ports
Post by: Victor Kirhenshtein on July 26, 2012, 11:17:10 PM
Either bug, or switch really does not provide state for these ports. Can you do nxsnmpwalk on .1.3.6.1.2.1.2.2 and send output to me?

Best regards,
Victor
Title: Re: stack ports
Post by: lindeamon on July 27, 2012, 10:13:14 PM
will do coming this sunday

Best Regards,
Lindeamon
Title: Re: stack ports
Post by: lindeamon on July 29, 2012, 01:25:32 PM
hi victor,
attached is the output you have requested

Best Regards,
Lindeamon
Title: Re: stack ports
Post by: Victor Kirhenshtein on July 30, 2012, 10:00:13 AM
Hi!

Switch reports interface operational status as 2 (down) for 2 of them and 6 (notPresent) for other two on each unit. NetXMS server translates "notPresent" state into UNKNOWN status, this is why you see some of 10G interfaces as unknown. It's a question if this is a correct interpretation of interface state, or it should be translated into CRITICAL status, as for DOWN state.

Best regards,
Victor
Title: Re: stack ports
Post by: lindeamon on July 30, 2012, 01:29:37 PM
hi victor,

i looked at the switches and i found that there is a difference between stack ports an 10gb ports.
there are module sockets for either 10gb uplink or stack ports and the module attached is for stack ports therefor the status indication of the switches are correct.
i was not familiar with this configuration which is different from cisco, hence my mistake

Best Regards,
Lindeamon
Text only | Text with Images