NetXMS Support Forum

Hi Guys,

First of all please excuse me, I am not that experienced with NetXMS. Long and boring story short I want to create a custom parameter that enables NetXMS to monitor the amount of file handles open. A senior colleague of mine informed me I need to add the below to the nxagentd.conf file:

ExternalParameterShellExec=FileHandlesAll(*):Command to be executed

After this I need to add a new parameter however when I click the Select... button next to Parameter FileHandlesAll doesn't appear there. Are we doing anything wrong?

Many thanks in advance.

Hi guys,

First of all, apologies as I am a complete and utter newbie to NetXMS and only just started using this at work.

We have a lot of manually and intentionally disabled ports in our networks and I am finding it a little bit inconvenient that these are flagging up as the switch icon has the red x. The ports are set to 'Expected state' DOWN, the ports 'Administrative State' and Oprtational State are both down and 'Status' as disabled but it still shows a rec circle with the line though (please see attached picture). If this an intended feature or by selecting other settings can I have this red circle to disappear and make it looks like a 'Normal' port?

One little observation I noticed is that when I right click on the interface, select 'Change interface expected status...' and change it to DOWN, the red circle disappears for about a minute, a question mark appears but then the red circle appears again. When I go back to 'Change interface expected status...' it's set as UP again, not DOWN which I changed previously. Is this normal?

Many thanks in advance!