NetXMS Support Forum

So I un-installed 1.2.10.
Installed 1.2.7 WebUI (Was getting errors but the service started)
re-installed 1.2.10 WebUI on top of 1.2.7 and it worked.

So I'm good to go on this one.

I already had active turned on and the subnets input, but that's not getting the IP addresses to show up. That's why I was hoping for something like an IP scanner so I could put a range in rather than individually. But I guess that's what the "active" part of the network discovery is suppose to do. Anyway, here is your SS.

Is there some way to do a IP Scan and then add any machines found in that scan to NetXMS? (Or am I trying to re-invent the wheel here...) I just don't want to manually add all the devices.

I installed it yesterday and let it run over night. Entire network didn't get many of the machines that are pingable from the host server's location.

I went into Configuration > Network Discovery and added all the vLANs I wanted it to check then turned off the "NetXMS Core" service when it wouldn't start poling the machines. I waited over an hour and it didn't add any machines out of the 10.2.x.x vLAN.

So I added 7 "seed" nodes in the vLANs I wanted it to discover.(That are also within the network discovery tab IP range) It still has not added any more machines within those vLANs after almost 2 hours. I verified that other machines on those vLANs can be pinged from the NetXMS server as well.

What am I missing here?

NetXMS version 1.2.10
Java 7u45
Java SE Development kit 7u21

When I try to turn on the WebUI service after the install I get this error:
Widows could not start the NetXMS WebUI on local computer. for more information, review the system event log. If this is a non-Microsoft service, contact the service vendor, and refer to service-specific error code 1.

From system log:
The NetXMS WebUI service terminated with service-specific error Incorrect function...

I received no errors during the install, and I can access NetXMS core on the server directly. I have tried un-installing and re-installing the Web UI with no luck. What do I need to do to get the Web UI to work?